Frame Relay Multipoint Subinterface - Static Mapping

Gunakan konfigurasi topology pada artikel sebelumnya

 Konfigurasi :
R1(config)#int s0/0.1 multipoint
R1(config-subif)#no frame-relay interface-dlci 102
R1(config-subif)#frame-relay map ip 12.12.12.2 102 broadcast



R2(config)#int s0/0.1 multipoint
R2(config-subif)#no frame-relay interface-dlci 201
R2(config-subif)#frame-relay map ip 12.12.12.1 201 broadcast

FRSW(config)#frame-relay switching
FRSW(config)#int s0/0
FRSW(config-if)#encapsulation frame-relay
FRSW(config-if)#frame-relay intf-type dce
FRSW(config-if)#frame-relay lmi-type cisco
FRSW(config-if)#frame-relay route 102 interface s0/1 201
FRSW(config-if)#no shut
FRSW(config-if)#int s0/1
FRSW(config-if)#encapsulation frame-relay
FRSW(config-if)#frame-relay lmi-type cisco
FRSW(config-if)#frame-relay intf-type dce
FRSW(config-if)#frame-relay route 201 interface s0/0 102

verifikasi :
R1#sh frame-relay map
Serial0/0.1 (up): ip 12.12.12.2 dlci 102(0x66,0x1860), static,
              broadcast,
              CISCO, status defined, active
R2#sh frame-relay map
Serial0/0.1 (up): ip 12.12.12.1 dlci 201(0xC9,0x3090), static,
              broadcast,
              CISCO, status defined, active
pastikan
R2#ping 12.12.12.1

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 12.12.12.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 216/255/312 ms