FRAME RELAY STATIC MAPPING

 

KONFIGURASI :

R1(config)#int s0/0
R1(config-if)#ip add 12.12.12.1 255.255.255.0
R1(config-if)#frame-relay map ip 12.12.12.2 102 broadcast
R1(config-if)#encapsulation frame-relay
R1(config-if)#no shut

R2(config)#int  s0/0
R2(config-if)#encapsulation frame-relay
R2(config-if)#ip add 12.12.12.2 255.255.255.0
R2(config-if)#frame-relay map ip 12.12.12.1 201
R2(config-if)#no shut

FRSW(config)#frame-relay switching
FRSW(config)#int s0/0
FRSW(config-if)#encapsulation frame-relay
FRSW(config-if)#frame-relay intf-type dce
FRSW(config-if)#frame-relay lmi-type cisco
FRSW(config-if)#frame-relay route 102 interface s0/1 201
FRSW(config-if)#no shut
FRSW(config-if)#int s0/1
FRSW(config-if)#encapsulation frame-relay
FRSW(config-if)#frame-relay lmi-type cisco
FRSW(config-if)#frame-relay intf-type dce
FRSW(config-if)#frame-relay route 201 interface s0/0 102

Verifikasi :

R1#sh frame-relay map
Serial0/0 (up): ip 12.12.12.2 dlci 102(0x66,0x1860), static,
              broadcast,
              CISCO, status defined, active

R2#sh frame-relay map
Serial0/0 (up): ip 12.12.12.1 dlci 201(0x66,0x1860), static,
              broadcast,
              CISCO, status defined, active

R2(config-if)#do ping 12.12.12.1

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 12.12.12.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 196/318/500 ms

Selain parameter static maaping, yang perlu diperhatikan keyword broadcast, dimana secara default frame relay termasuk network non broadcast, maka routing apapun tidak bisa berjalan sesuai yang diinginkan.